From: Christian Bourgeois (cbourgeois@alti.fr)
Date: Thu Dec 14 2000 - 19:06:40 CET
Hi everybody.
This is my first message on the forum, so I hope everything will go fine !
I have a problem with mulinux and my netword card :
> I have installed mulinux on a dos-16 FAT partition 63MB in "C:\MULINUX".
> I have dowloaded WKS and SRV modules
> I have ran UNPACK.BAT, followed by BOOT.BAT (no floppy required, a very
good point !!!)
>
> Everything works fine.
>
> info/pci tells me that the netword card is using IRQ 5 and I/O 0xE000.
>
> It is a VIA Fast Ethernet Card (or something like that).
>
> If I well remember, it is based on a rtl8139 chip, so it should work with
> rtl8139 netword module.
>
> But,
>
> when "setup eth0 CARD=rtl8139 IRQ=5 IO=0xE000 IP=192.168.0.203" i always
> get the error "Symbol 'io' not found" !!!
> I haven't figured out where the problem comes from.
>
> Before installing mulinux on the computer, I had tested it
> with floppy disks (with SRV only, not WKS), and it worked fine with that
> card. But is was not the last version, it was the 11r1 I think.
>
> I tested the above hard disk installation with the 10r5 and 11r2, and both
> give the same error.
>
Do you have any idea ?
It'll be very helpfull, as I'm going to install it on about 25 computers !!!
Also, is there any way to protect the "C:\LINUX" from being modified when in
DOS mode ?
Thanks a lot,
Cheers,
Christian.
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:17 CET